Promoting high energy Na4MnCr(PO4)3 capable of three-electron reaction for SSSMBs

They published their work on June. 9 in Energy Material Advances.

"The development of high safety and high energy density SIBs is imperative," said paper author Zhongyue Wang, lecture with the College of electronic and optical engineering & college of flexible electronics (future technology), Nanjing University of Posts and Telecommunications. "Currently, great progress has been made in sodium-ion batteries, but their energy density is still much lower than LIBs limited by the cathode."

Wang explained that NASICON-type phosphate (Na_xMM’(PO₄)₃, M, M' =transition metal Ti, V, Cr, Mn, Fe, Co and Ni) is regarded as the most competitive high energy cathode benefiting from its stable structure, 3D open frameworks and structural diversity.

"Na_xMM'(PO₄)₃ contain an enormous Na reservoir with potential for up to four extractable Na, however it is uncommon to perform reversible extraction/insertion of more than two Na ions," Wang said. "One/two-electrons electrochemical reaction per formula unit makes most phosphate cathode provide low energy density (<500 Wh kg^-1). Hence, exploring a cathode enable three-electron reaction and high operating voltage is extremely desirable to achieve a higher energy density for SIBs."

But not all Na_xMM'(PO₄)₃ cathodes are capable of three-electron reactions. According to Wang, you can't have your cake and eat it. Cheap Ti and Fe -based phosphates cathodes can achieve a specific capacity of over 170 mA h g^-1, but the lower operating voltage results in a low energy density. On the other hand, extra-high voltage plateau of Co or Ni-based phosphates cathodes (over 4.5 V vs Na⁺/Na) poses a great challenge to the electrochemical stability of electrolyte and cause its decomposition inevitably. Na₄MnCr(PO₄)₃, due to its higher voltage plateau (4.34 V for Cr^4+/3+, 4.11 V for Mn^4+/3+, 3.43 V for Mn^3+/2+), high theoretical energy density (566 Wh kg^-1), low cost and low/non-toxic, will become an ideal cathode for SIBs.

However, there are a few reports on Na₄MnCr(PO₄)₃, the results are very inconsistent and the cycle performance over 4.5 V cutoff voltage windows is very poor. Wang said that the main reason is the decomposition of organic electrolyte under high voltage. Wang and his team synthesized carbon coated high energy Na₄MnCr(PO₄)₃, and more importantly, realized better cycle stability in solid state sodium metal batteries.

"In this paper, the surface carbon content of Na₄MnCr(PO₄)₃ was controlled by adjusting the molar ratio of citric acid and metal ions, and the electrochemical performance of Na₄MnCr(PO₄)₃ was optimized, an ultra-high energy density of 523.6 Wh kg^-1 was obtained," Wang said. "The as-prepared Na₄MnCr(PO₄)₃@C were assembled into solid state sodium metal batteries by matching Na_3.3La_0.3Zr_1.7Si₂PO₁₂(3 wt% Na₂B₄O₇) ceramic electrolyte, and achieved a more stable cycle than that of half-cell."

"Better cyclic stability is attributed to the super high ionic conductivity (1.2 mS cm^-1) of Na_3.3La_0.3Zr_1.7Si₂PO₁₂(3 wt% Na₂B₄O₇) and its wide electrochemical stability window (>5 V)," Wang said.

"There is still a lot of room for improvement in Na₄MnCr(PO₄)₃-based solid-state batteries," Wang said. "For example, ultra-thin composite solid electrolyte is expected to improve the interface issues and increase the energy density of SSSIBs, and finally to realize the practical applications."

Other contributors include Cheng Tang, Zhi Wang, Qing Zhang, Peng Lv, Kehan Yu, Jiajin Zheng and Wei Wei, College of electronic and optical engineering & college of flexible electronics (future technology), Nanjing University of Posts and Telecommunications.

National Natural Science Foundation of China (62075100), and Natural Science Foundation of Nanjing University of Posts and Telecommunications (No. NY220052 and NY221069) supported this work.

###

Reference

Authors: ZHONGYUE WANG , CHENG TANG, ZHI WANG, QING ZHANG, PENG LV, KEHAN YU, JIAJIN ZHENG, AND WEI WEI

Title of original paper: High-Energy Na₄MnCr(PO₄)₃@C Cathode for Solid-State Sodium Metal Batteries

Journal: Energy Material Advances

DOI: 10.34133/energymatadv.0036

Affiliations: College  of  Electronic  and  Optical  Engineering  and  College  of  Flexible  Electronics  (Future  Technology),  Nanjing University of Posts and Telecommunications, Nanjing 210023, PR China.

About Dr. Zhongyue Wang:

Zhongyue Wang received his PhD degree from Institute of Advanced Materials (IAM), from Nanjing University of Posts and Telecommunications (NJUPT) in 2014. Once studied in the State Laboratory of Transient Optics and Photonics, Xi'an Institute of Optics and Precision Mechanics of CAS for one and a half year (2011.02~2012.08). Since 2014, he began to work in Nanjing University of Posts and Telecommunications (NJUPT). His research interest is mainly focused on micro-nano fluorescent materials, energy storage materials and devices, optical glass/ceramic/fiber and so on. He has published more than 30 scientific papers with 370 citations, and the journals include J. Mater. Chem., Nanoscale, Opt Lett, J. Am. Ceram. Soc., Carbon, Small, etc.