News Release

New high-purity plutonium sources produced at Los Alamos

Peer-Reviewed Publication

DOE/Los Alamos National Laboratory



Full size image available through link below or through contact.

NEW ORLEANS, March 24, 2003- For the first time since 1987, new high-purity plutonium sources for use as primary analytical chemistry standards have been produced at Los Alamos National Laboratory using a new extrusion method developed at the Laboratory.

The techniques and equipment used in the fabrication of the new plutonium sources will be the topic of a talk by Gerald Coriz of the Laboratory's Nuclear Materials Technology Division at the annual meeting of the American Chemical Society. Coriz's talk will be held Monday, March 24, at 1:30 p.m. in Room 391 of the Morial Convention Center, 900 Convention Center Boulevard, New Orleans, La.

Plutonium sources used as standards in analytical chemistry must be of extreme purity, 99.99 percent pure, free of contaminants and surface oxidation. Plutonium is extremely prone to oxidation and can burn when exposed to the air. The plutonium sources fabricated at Los Alamos had to be made in an oxygen-free environment, at less than 10 parts per million, and sealed under vacuum in glass ampoules to assure their utility as primary standards.

"In the past, analytical standards were made with a 'nibbling' method," said Coriz. "You would start with a thin plutonium plate and nibble little pieces off it. Although it was never proven, wear on the nibbling tool was thought to be a source of contamination with this method. It was for this reason we looked at an extrusion process, with planning that started in 1997."

After many delays and technical problems, a press system built into a specially modified glove box was finally in place in May of 2002. The process uses 15,000 pounds of force at 75,000 pounds per square inch to squeeze machined plutonium plugs, one and a half inches long by one half inch in diameter, through a specially designed extrusion die. The plugs, heated to 785 degrees Fahrenheit and roughly the consistency of taffy, come out of the die as a 5/32nd-inch diameter wire, which was then cut into individual sources, each weighing approximately one gram. Each source is about the size of a small hearing aid battery, one quarter inch long and cut to a tolerance of plus or minus one tenth of a gram.

"At room temperature plutonium is very hard but also very fragile," said Coriz. "As the soft plutonium wire came out of the extrusion die it hardened very quickly as it cooled. It produced a shape that was easy to cut with a small re-bar cutter even though the material was fairly brittle and, because of the non-reactive materials used in extrusion die, wasn't contaminated."

The Laboratory produced 1,200 of the one-gram plutonium sources. The majority of the sources are currently undergoing analytical evaluation at the Department of Energy's New Brunswick Laboratory in Illinois. A few of the sources are also undergoing evaluation at Los Alamos. Once accepted, the sources will be made available to nuclear industry and approved governments worldwide. Some of the sources will be used at Los Alamos in the Laboratory's nuclear weapons surveillance and certification programs.

"This was a major challenge," said Coriz. "The project was postponed several times, once during the Cerro Grande forest fire. And there were many difficult technical challenges. But overall, the project was very enjoyable. Even though a lot of things got in our way, we were able to manage and produce an excellent product."

###

Note to news media/editors:
Photos available on-line at: http://www.lanl.gov/worldview/news/photos/PuSource-vert.jpg.

Los Alamos National Laboratory is operated by the University of California for the National Nuclear Security Administration (NNSA) of the U.S. Department of Energy and works in partnership with NNSA's Sandia and Lawrence Livermore national laboratories to support NNSA in its mission.

Los Alamos enhances global security by ensuring the safety and reliability of the U.S. nuclear stockpile, developing technologies to reduce threats from weapons of mass destruction, and solving problems related to energy, environment, infrastructure, health and national security concerns.

For more Los Alamos news releases, visit World Wide Web site www.lanl.gov.


Disclaimer: AAAS and EurekAlert! are not responsible for the accuracy of news releases posted to EurekAlert! by contributing institutions or for the use of any information through the EurekAlert system.