News Release

Microchannel technology bodes well for ammonia as refrigerant

Peer-Reviewed Publication

University of Illinois at Urbana-Champaign, News Bureau

CHAMPAIGN, Ill. — Modern microchannel tube technology – widely used in the automotive industry for heat exchangers – offers an excellent opportunity to rethink the use of ammonia as a refrigerant, say scientists at the University of Illinois.

In a recent feasibility study, UI researchers used a commercially available microchannel heat exchanger to create a 15-kilowatt refrigeration system with the smallest ammonia charge in the world. A similar technique could be used to significantly reduce the amount of ammonia in large chillers.

Ammonia is widely accepted as the most efficient and environmentally friendly refrigerant. But its unpleasant odor and mild toxicity have limited its use to industrial plants away from heavily populated areas. To reduce risk and expand applications in urban areas, the amount of ammonia required to charge refrigeration and air conditioning systems must be substantially reduced.

"New designs in microchannel heat exchangers allow much smaller refrigerant charges to be used than in conventional heat exchangers," said Pega Hrnjak (pronounced PEG-uh HER-nee-ak), a UI professor of mechanical and industrial engineering and co-director of the university’s Air Conditioning and Refrigeration Center. "Charges in these systems could be hundreds of times smaller than in conventional systems."

To explore the feasibility of using air-cooled condensers with microchannel tubes and ammonia as the refrigerant, Hrnjak and graduate research assistant Andrew Litch constructed an experimental chiller facility. The laboratory facility consisted of a re-circulating calorimetric wind tunnel, an ammonia chiller test bed and a pumped glycol heat-recovery loop.

The researchers then evaluated two similarly sized aluminum condensers: one with a parallel microchannel tube arrangement and the other with a single serpentine macrochannel tube. Measurements of heat transfer, pressure drop and charge were taken over a variety of operating conditions.

"The microchannel system significantly outperformed the conventional system," Hrnjak said. "The amount of refrigerant was reduced several times, while significantly increasing the heat transfer capability." Using microchannel tubes, Hrnjak and Litch successfully reduced the refrigerant charge to 2.5 ounces of ammonia per ton of evaporator capacity – considerably lower than the 12.5 ounces per ton used in current air-cooled ammonia chillers. Further charge reduction would be possible through better design of the condenser headers and optimization of the heat exchanger as a whole, Hrnjak said.

"This is not only an excellent way to reduce refrigerant charge, but also to drastically reduce the condenser size," Hrnjak said. "Chillers could be reduced to nearly one-third their present size."

###

A paper discussing the researchers’ findings has been accepted for publication in the International Journal of Refrigeration. The Modine Manufacturing Co., Hydro Aluminum and the International Institute of Ammonia Refrigeration funded the research.


Disclaimer: AAAS and EurekAlert! are not responsible for the accuracy of news releases posted to EurekAlert! by contributing institutions or for the use of any information through the EurekAlert system.