HEREFORD -- Clean manure may sound like an oxymoron, but Dr. Brent Auvermann is working with feedyard owners to help them get the most "spark" from it as a fuel source.
Auvermann, a Texas Cooperative Extension engineering specialist, hosted "Producing High-Value Manure for BioFuels and Fertilizer" recently in Hereford. The meeting outlined work by Texas Agricultural Experiment Station researchers to determine best management practices for scraping manure from the feed pens. "We're doing something that has never been done before," said Arles "Bugs" Graham, Panda Energy International's general manager for the Hereford plant. Graham spoke at the meeting. "We're using your manure as an energy source," he said. "It's a very complex process."
After starting up the plant with natural gas as the boiler fuel, Panda Energy will eventually use manure as a fuel source when producing ethanol for an E10 fuel blend, Graham said.
The plant will initially process corn for ethanol, although the company is looking at alternative sources of starch to make the ethanol, and it will produce distiller's grains as a by-product.
"But manure is our future," Graham said, estimating each plant will use 1,500 tons a day.
Jim Adams, Panda Energy vice president-fuels, said the plant will begin asking yards in June to sign up for a percentage of their manure. The past winter was a wake-up call, Adams said. Sometimes when the weather is too wet, manure can't be harvested from the pens. Manure will be used by this fall, so "we have to start stockpiling now" to ensure a steady supply.
Adams said the plant will use manure on a six-day basis, requiring 70 to 80 truckloads per day. Panda's contractor will collect from the pens when they are dry enough, but will need to pull from stockpiles when pen surfaces are too wet.
Quality is the biggest issue, Auvermann said. The manure needs to burn at a minimum rate of 2,758 British thermal units per pound of manure. That number changes according to the amount of pollutants - moisture and dirt - included when the pen is scraped.
If all the water and contaminants were removed from the manure, the highest quality would be 8,500 Btu, "but we can't do that, because we can't take the ash out completely," he said.
Manure from soil-surfaced pens may not always meet the minimum heating value on an as-received basis, Auvermann said. Feedyard operators will have to take some steps to improve it.
The timeliness of collection and depth of scraping will be key to keeping dirt content below 60 percent and moisture content below 20 percent, he said. "Paving the pens with a crushed ash or a fly-ash material (from coal-fired power plants) will end up returning to you in the form of heating value û big time," Auvermann said.
Partially composted manure from paved pens can have a heating value almost equivalent to that generated by burning Texas lignite coal, he said.
Feedyard owners should consider the process as "harvesting manure" rather than cleaning pens, Auvermann said. The ultimate goal is to have a hard, smooth, well-drained corral surface. Implementing good practices will pay at the bottom line, he said.
Conscientious manure harvesting can result in higher fuel and fertilizer values, reduced feed requirements for cattle, improved pen drainage, and reduced odor, dust and flies.
Writer: Kay Ledbetter, 806-677-5608, skledbetter@ag.tamu.edu